This mala was designed for the kindergarten Balavihar class. Our lesson was "J is for Japa."
Materials
• 27 beads of your choice
• 1 meru bead — a little larger than the japa beads. (The center hole must be able to fit 2 pieces of yarn.)
• One piece of yarn (six stranded crochet cotton is good)
• Elmer's Glue
Directions
1. Dip one end of your cotton thread into the Elmer's glue. Roll the glued end between your fingers until it starts to form a hardended tip. Do the same to the other end. (see photo A below)
2. With one end of the cotton thread all 27 beads. (see photo B below)
3. Take both ends of the cotton and insert them through the meru bead. (see photo C below)
4. Make a big knot at the botton of your meru bead. You might have to knot a few times to make sure that the the knot is bigger than the hole of your bead.
5. Trim the cotton ends to a desired length.
6. You can make a simple tassle by untwisting both ends of the cotton.
* If you want to make a japa mala consisting of 108 beads, the technique is the same. To make an authentic mala a knot must be tied between each bead. (see photo D below)
Photo A
Photo B
Photo C
Photo D